PDD Case Study #1: NO Feedback
0 of 20 Questions completed
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 20 Questions answered correctly
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
According to the Municipal Code in the enclosed documentation, what is the minimum width of the driving aisle if the new residence parking was in a facility?
How many exhaust vents are identified for the New Residence?
The site consists of a single-story residence. After 2 years of living in the house, the Owner decides to add a second story to the house on top of the existing structure. What is the first recommendation the Architect should provide?
The Owner decides to change the facade material from metal panel to EIFS construction after approving the Design Development Phase. What does the Architect request from the Owner?
When thinking about concrete beams and structural reinforcement, what is the purpose of stirrups in a beam?
According to the labeling of materials or assemblies is an indication that the materials or assemblies have been subjected to testing, inspection, and/or other operations by the labeling agency, the interior walls between the Living Room and the Master Bedroom have the following sheathing label. What is wrong with the selected sheathing when reading the label?
The Architect is interested in keeping a clear decision matrix for the Owner. Which is the key point within the design and construction process where specific decisions should be made regarding the building enclosure?
During which Phase of the construction documentation process is it best to preliminarily review the project details that will be used in the Construction Documents?
Considering that the Owner has the west side of the property available to build a 600 sq. ft. dwelling unit, locate the two best areas for analysis and observation through tests of materials by borings or other subsurface explorations to find the appropriate locations for the footprint of the dwelling unit.
When determining materials, assembly U-factors, air and water-barrier details, and transitions, it is best to consider information from which source?
Which drawing series (plans, elevations, sections, details, schedules) are the most practical location for mapping out exterior active joints in the building facades?
The Owner wants an Accessory Dwelling Unit to be constructed of Type V-B construction. What is the maximum area to which this building can be constructed and does the New Small Rental qualify?
The detail 2/A-5.3 has a clouded revision 1 because of a comment by the AHJ, according to the code reviewer what is the main purpose of requiring a porous material installation type before the slab is poured?
All of the following issues should be carefully considered when developing details for a project, EXCEPT for:
The Architect needs to excavate a trench to install a french drain along the East and West porch, select the best location to dig the trench as close as possible to the slab and below the load-bearing footing plane.
Legally, the Architect occupies three different positions as the professional service phases progress from inception of Design to completion of Construction Contract Administration. The three separate and distinct roles recognized in law are:
What is the meaning of quasi-judicial officer?
The New Residence is part of a greater development in the area, since it is the first house the developer must follow the technical requirements of HUD’s Fair Housing Guidelines, what Type of unit will the New Residence need to be considered?
The Architect needs to determine the number of penetrations required according to the vents specified by the plumbing engineer, which vents from the vignette enclosed daylight at the roof? (select two)
The Owner is interested in adding an open space to lease the space to a church nearby for worship. The one-story Group A-3 religious space building addition of Type III construction may be considered under the unlimited area provisions, provided the space floor is located a maximum of how many inches above or below grade level? Use the provided the excerpt from the IBC 2018 code in the enclosed vignette to solve the best answer.