PDD Case Study #3: NO Feedback
0 of 20 Questions completed
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 20 Questions answered correctly
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
What type of water closet must be used in the accessible water closet bathroom Room 101?
As the Architect is getting close to the final presentation notices a silver tank in front of the rendering, where on the site is the Alternate fuel tank located?
Chapter 6 of IBC 2018 specifies the minimum fire rating of exterior walls based on the fire separation distance and creating an imaginary line as reference. Assume that all buildings shown on Sheet C1.01 are on the same lot, where would the imaginary line be drawn? (select two)
Indicate the main component on a foundation drain that allows for the hydrostatic pressure to be relieved in the drainage system, in reference to detail 3/A8.11?
The Architect is reviewing the Reflected Ceiling Plan of the Second Floor, see Sheet A6.20. Fill in the blank for what type of ceiling is represented in the following areas?
In reference to details 1 and 3, Sheet A8.11 where is the waterproofing located?
Identify the wall type that pertains to key legend 11 on sheet A8.11 and is considered 1-Hour Fire Rated Partition on Sheet A10.10
Is room 102, Internal Circulation considered a dead-end corridor? What is the maximum allowable distance for a dead-end corridor in a sprinklered building?
There are four floor drains located in the Apparatus Bay and each is centered in a quadrant. What is the maximum vertical distance of the floor drain at the southeast corner (follow the project north indication) of the Apparatus Bay if the slope is 1/8”:12”?
The Architect is designing the vestibule entry with a 24” wide countertop. Based on Accessibility Codes, what is the maximum height of a service counter?
There are three types of frames defined in the Building Code: ordinary moment frames (OMF), intermediate moment frames (IMF) and special moment frames (SMF). Since the building is near an earthquake fault, where in the building would the structural engineer pay close attention to the special moment frames?
What is the manufacturer’s Basis of Design for the air conditioner unit which is found on the Roof?
What are the three parts of the means of egress?
Originally, buildings used the lath-and-plaster method for finishing walls. This method is now obsolete and has been replaced. What is the proposed material shown at the East and South Elevations?
What type of glazing is used between the Apparatus Bay with 08 500.A2 annotation?
VAV 13 is one of the mechanical units located in the Locker Foyer, what’s the maximum CFM of the equipment?
What type of exterior material is shown on detail 1/A10.10
What is the purpose of the Aluminum jacket protection on the refrigerant piping for the AC unit on the roof. (fill in the black)
Construction types are found in the IBC Chapter 6 and are also indicated in the construction drawings to provide information to the building official regarding proposed condition of the wall system. What type construction type has been selected for the fire house?